The standard stone engraving machines and tombstone engraving machines are dual cooling. On the one hand, because the stone material is hard, it is necessary to water-cooling the cutter head when working. On the other hand, it is water cooling the spindle to prevent the spindle temperature from being too high, which plays a certain role in protecting the spindle. However, if the customer does not pay attention to or do not follow the training steps, there will be no water dry burning phenomenon, causing serious damage to the machine itself.

Stone carving machine

一，石材雕刻機主軸干燒更容易導致的就是主軸發熱過度,溫度過高導致燒掉。一般主軸燒掉后,就得需要把壞的返廠維修。然后修好再從工廠發回來,這樣一來一回的周期大約1周左右,會嚴重耽誤正常加工工期，如果客戶那邊著急要訂單的話，會造成很大的損失。所以說客戶在加工的時候，一定要按照工廠技術員的培訓操作，保證機器的正常使用，延長機器的適用周期。

1、 Stone engraving machine spindle dry burning is the most easy to lead to excessive spindle heating, high temperature leading to burning. Generally, after the spindle is burned, it is necessary to return the damaged one to the factory for repair. Then it is repaired and then sent back from the factory. The cycle is about one week, which will seriously delay the normal processing period. If the customer is in a hurry to order, it will cause great losses. Therefore, when processing, customers must follow the training of factory technicians to ensure the normal use of the machine and extend the applicable period of the machine.

二，如果石材雕刻機的主軸沒有通水冷卻,就會一直處于持續高溫發熱狀態。容易導致主軸出現抖動或者錯位,雕刻忽快忽慢,不穩定的現象。一方面會使精度會受到影響，另一方面主軸錯位會使得雕刻樣品錯位，雕刻出的樣品自然漏洞百出,非常不精細。

2、 If the main shaft of the stone carving machine is not cooled by water, it will always be in a state of continuous high temperature heating. It is easy to lead to spindle shaking or dislocation, carving fast and slow, unstable phenomenon. On the one hand, the accuracy will be affected, on the other hand, the spindle dislocation will make the engraving sample dislocation, carving out the sample naturally full of holes, very not fine.